I milled up a pile of western cedar boards for use as the cabin sole. It's mostly knot free and the knots I have are small-ish. Here is the port side roughed in.
Posts
Milling time!
While I wait for my hull epoxy to dry I'm going to get started on the floorboards. I've got a number of large planks of western cedar that I'm going to use. First I have to mill these 3-in x 15-in x 10-ft planks down to size.
Initial Hull glassing finally done
Finally done with the inside hull fiberglassing. As you can see, I'm following the steps suggested by Brent's blog and doing alot of work on the lower hull before installing the sides. Getting these areas around the floor boards glassed was hard enough - not sure I could have gotten there if the sides were on. I also did a variation on the way I glassed between the floors. First I put glass in each corner. I actually used a bigger piece that extended farther toward the center of the centerboard. Then I glassed the sides of each floor board with it extending out over the hull panel. Finally I laid a wide strip down the center. This took longer, but was much easier to lay down. The first section I tried using a single sheet and total messed it up. This worked well.